Everbuild Cemstrip further informationYield: Approx. 10m2 per litre depending on porosity of substrate.Product InstructionsPackaging1L and 5L plastic containers, 1L sprayable containerColourThin green/yellow liquidShelf Life24 months form date of manufacture.Storage ConditionsKEEP AWAY FROM CHILDREN. Store away from alkaline products and bleach at 5°C to 25°CDensity1.09g/cm3 at 20°CpH-Value1.4 - 1.7Everbuild Cemstrip Application InstructionsMixingCleaning general stains and ingrained dirt from paths, patios and horizontal surfaces. 2 parts water to 1 part EVERBUILD CEMSTRIP – Cleaning light mortar stains from paths, patios, walls or vertical surfaces.1 part water to 1 part EVERBUILD CEMSTRIP – Cleaning heavy mortar stains from walls or vertical surfaces. Neat – Cleaning tools, cement mixers and other building equipment.Substrate PreparationWhen cleaning paths, patios, cement stains etc. from surfaces always thoroughly wet surfaces prior to application. Do not apply to a dry surface. Always test a small inconspicuous area prior to full application. When cleaning tools and equipment pre-wetting is not necessary.Everbuild Cemstrip ApplicationGeneral Cleaning: Moisten surfaces with water and apply EVERBUILD CEMSTRIP with brush or low pressure spray (avoiding mist formation) from the top of the area downwards. Leave for 5-10 mins then scrub/wash off with a hose, brush or power washer until the surface is clean. Nev- er allow the product to dry on surfaces. Where a second application is necessary, repeat the procedure above.Cleaning tools/equipment: EVERBUILD CEMSTRIP will remove fresh cured cement and wet or semi-cured cement from tools. Spray onto item in question. Leave for 15 mins to act (light stains) or up to 3 hours for heavy contamination. Wash off the product with clean water. Use of a scourer will assist removal of stubborn stains. Use a hot power wash to assist removal of staining from mixing equipment. After removal, always spray tools with Everbuild XT44 Maintenance Spray (or any other proprietary maintenance spray) to prevent further corrosion/rust.LimitationsDo not use on marble, granite or travertine.Do not use on coloured cement-based pavers.Always test a small inconspicuous area prior to full application, especially on coloured flags/stones.Do not use on soft metals such as lead brass, copper or aluminium.Do not apply to dry surfaces or allow Everbuild Cemstrip to dry on the surface.Always thoroughly rinse equipment to prevent further rusting/corrosion.Avoid overspray on sensitive surface such as brass, copper, stainless steel and aluminium. Remove any excess material or spills immediately with clean fresh water.Cleaning mortar or concrete from tools – the stronger or older the mix, the more difficult it will be to remove.Always wash out spray equipment immediately after use with clean fresh water.It is the user’s responsibility to determine suitability for use. If in doubt contact technical services for advice. Categories: All Products, Outdoor Products - Pallet Deals and Bulk Buy
