Description Reviews (0) The DC-1 Downrigger release clip has the same features as the OC-1 (except the stainless bail is not gold titanium-nitride coated), and should be attached directly to the cable above the downrigger ball. This is best accomplished by threading one side of the clip onto the cable, then placing a crimp on the cable before passing it through the remaining half of the DC-1. Once the cable has been termi-nated with the cannonballs snap, the DC-1 can be positioned approximately one foot above the ball. The crimp should then be swaged into place. Note that the DC-1 clip must be positioned with the adjustment-slider down or towards the bail. The fishing line should be twisted 5 to 10 times before placing it over the release bail. Reviews There are no reviews yet. Be the first to review “Aftco Goldfinger Downrigger Release Clip” Cancel replyYour email address will not be published. Required fields are marked *Your rating * Rate… Perfect Good Average Not that bad Very poor Your review *Name * Email * Save my name, email, and website in this browser for the next time I comment.
